What I want to accomplish with this idea. The reason Im using a Curve, is to limit the travel of those servos, so they will not fully deflect with full aileron stick travel. They both operate from the aileron stick. Maybe something else? But will that be enough? Does applying "consumption" to a current sensor with a value in "A" get me Ah? Or does it just get me A + A + A + A.? I really could use a description of the steps required to turn the value of the FCS-150A into a "mAh used" (or even just Ah if I can't convert) value. Ive set up two Curve based mixers, one to a PAN servo and the other to a TILT servo. Which "operator" do I use for the calculated type? Consumption or Totalize sounds like they might do the trick. Where I am stuck is creating that virtual 'mAh" sensor. Assuming that sensor is called "mAh", I believe I can figure out how to use mAh in the telemetry screen, for switch-based voice readout, and for alarms. ar610 ar8000 spm4649t micro telemetry faq radix hardware brainfpv vector flight. I want it on the Telem screen, available for value readout when I flip a switch, and to have alarms set so when I get near 60% 70% and 80% of battery capacity (of course, I'll expect to have my battery capacity as a global variable, assume it is a constant for now).įrom what I can piece together, is seems that I need to create a new sensor with type = "Calculated". Even nicer is with signal loss you can set the receiver up to circle at. What I would like is a "mAh used" value on the telemetry screen. You can check if telemetry is working correctly by going to the Telemetry page on the Taranis (press menu button once, and keep pressing page. For X series receivers such as R-XSR, XSR and X4R-SB, you will first need to setup Smart Port. I have a telemetry screen setup showing the flight timer, RSSI, and Curr. In order to allow the Taranis know the voltage of the battery on your quad, telemetry is required. After that the videos invert the telemetry and their radios receive the new readings. I turned the Taranis on and into discover new sensors. I have my PDB soldered and plugged correctly into VBAT. Rememberalarm voltage / voltage ration / 3.3 x 25502 2s 04 3s 064s IF you reeeally enjoyed the video or it helped please donate using the link below, ev. Followed videos in clean flight using soft serial 2 (pin 8) on and telemetry on (set to FrSky) as well as VBAT. I have the sensor auto-discovered, the FCS-150 showed up as "Curr" with units in "A"mps, Precision = 1, Ratio and Offset both 0.0. Trying to Set up telemetry to my Taranis. I have read a bunch and watch various videos describing the process on OpenTX 2.0. I am very familiar with doing some fairly complex stuff in OpenTX, but I am completely new to the telemetry section. And don’t forget to enable Telemetry feature in Configuration tab. Multiplex M-Link telemetry can send up to 16 measures from all sensors on board. In the port tab, enable Frsky under the telemetry dropdown list for the UART you are using for Telemetry. I have an FCS-150A current sensor plugged into an X6R bound to a Taranis running 2.1.3. When used on FRSKY radio, this system offers the standard measures plus. Hopefully this is the right forum, if not please let me know or maybe a moderator can move it.
0 Comments
Leave a Reply. |